Expand description
SDM72D-M-2 Three Phase Four Wire Energy Meter
Structs§
- Address
- Address of the Modbus RTU protocol for the RS485 serial port. The address must be in the range from 1 to 247.
- Auto
Scroll Time - Automatic display scroll time in seconds. The time must be in the range from 0 to 60.
- Export
Energy Active - Export
Total Power Active - Frequency
- Import
Energy Active - Import
Total Power Active - L1Current
- L1Power
Active - L1Power
Apparent - L1Power
Factor - L1Power
Reactive - L1To
L2Voltage - L1Voltage
- L2Current
- L2Power
Active - L2Power
Apparent - L2Power
Factor - L2Power
Reactive - L2To
L3Voltage - L2Voltage
- L3Current
- L3Power
Active - L3Power
Apparent - L3Power
Factor - L3Power
Reactive - L3To
L1Voltage - L3Voltage
- LtoL
Average Voltage - LtoN
Average Current - LtoN
Average Voltage - Meter
Code - Meter code SDM72D-M-2 = 0089
- NetKwh
- Neutral
Current - Password
- Password must be in the range from 0 to 9999.
- Pulse
Width - Pulse width for the pulse output in milliseconds.
- Reset
Historical Data - Reset the historical saved data.
- Resettable
Export Energy Active - Resettable
Import Energy Active - Resettable
Total Energy Active - Resettable
Total Energy Reactive - Serial
Number - Software
Version - The software version showed on display
- Total
Energy Active - Total
Energy Reactive - Total
Line Current - Total
Power - Total
Power Apparent - Total
Power Factor - Total
Power Reactive
Enums§
- Backlight
Time - Back light time of the display in minutes. The time must be in the range from 1 to 120.
- Baud
Rate - Baud rate of the Modbus RTU protocol for the RS485 serial port. Supported rates are: 1200, 2400, 4800, 9600, 19200
- KPPA
- KPPA (Key Parameter Programming Authorization) write the correct password to get KPPA. This will be required to change the settings.
- Parity
AndStop Bit - Parity and stop bits of the Modbus RTU protocol for the RS485 serial port.
- Pulse
Constant - Pulse constant for the pulse output in impulses per kilo watt hour.
- Pulse
Energy Type - Pulse energy type for the pulse output. This is the value that the pulse output returns.
- System
Type - The system (wiring) type.
Traits§
- Modbus
Input Register - Input registers are used to indicate the present values of the measured and calculated electrical quantities. Modbus Protocol function code 04 is used to access all parameters.
- Modbus
Param
Type Aliases§
- Word
- 16-bit value stored in Modbus register.