Enum rp2040_pac::i2c0::ic_enable::ABORT_A

pub enum ABORT_A {
    DISABLE = 0,
    ENABLED = 1,
}

When set, the controller initiates the transfer abort. - 0: ABORT not initiated or ABORT done - 1: ABORT operation in progress The software can abort the I2C transfer in master mode by setting this bit. The software can set this bit only when ENABLE is already set; otherwise, the controller ignores any write to ABORT bit. The software cannot clear the ABORT bit once set. In response to an ABORT, the controller issues a STOP and flushes the Tx FIFO after completing the current transfer, then sets the TX_ABORT interrupt after the abort operation. The ABORT bit is cleared automatically after the abort operation.

For a detailed description on how to abort I2C transfers, refer to ‘Aborting I2C Transfers’.

Reset value: 0x0

Value on reset: 0

Variants

DISABLE = 0

0: ABORT operation not in progress

ENABLED = 1

1: ABORT operation in progress

Trait Implementations

impl Clone for ABORT_A

fn clone(&self) -> ABORT_A

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for ABORT_A

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl From<ABORT_A> for bool

fn from(variant: ABORT_A) -> Self

Converts to this type from the input type.

impl PartialEq for ABORT_A

fn eq(&self, other: &ABORT_A) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for ABORT_A

impl Eq for ABORT_A

impl StructuralPartialEq for ABORT_A