Enum rp2040_pac::i2c0::ic_data_cmd::STOP_A

pub enum STOP_A {
    DISABLE = 0,
    ENABLE = 1,
}

This bit controls whether a STOP is issued after the byte is sent or received.

• 1 - STOP is issued after this byte, regardless of whether or not the Tx FIFO is empty. If the Tx FIFO is not empty, the master immediately tries to start a new transfer by issuing a START and arbitrating for the bus. - 0 - STOP is not issued after this byte, regardless of whether or not the Tx FIFO is empty. If the Tx FIFO is not empty, the master continues the current transfer by sending/receiving data bytes according to the value of the CMD bit. If the Tx FIFO is empty, the master holds the SCL line low and stalls the bus until a new command is available in the Tx FIFO. Reset value: 0x0

Value on reset: 0

Variants

DISABLE = 0

0: Don’t Issue STOP after this command

ENABLE = 1

1: Issue STOP after this command

Trait Implementations

impl Clone for STOP_A

fn clone(&self) -> STOP_A

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for STOP_A

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl From<STOP_A> for bool

fn from(variant: STOP_A) -> Self

Converts to this type from the input type.

impl PartialEq for STOP_A

fn eq(&self, other: &STOP_A) -> bool

This method tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

This method tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for STOP_A

impl Eq for STOP_A

impl StructuralPartialEq for STOP_A