Struct rog_fan_curve::Curve

pub struct Curve { /* fields omitted */ }

Implementations

impl Curve

pub fn new() -> Self

pub fn from_config_str(config_str: &str) -> Result<Self, String>

Create a Curve from a config string

See the crate level documentation for information about the config string format.

Err results will contain a human readable string describing why the config string isn’t valid.

pub fn as_config_string(&self) -> String

Create a config string for a Curve

See the crate level documentation for information about the config string format.

pub fn check_safety(&self, fan: Fan) -> Result<(), UnsafeCurveError>

Checks if the curve is “safe”

This checks if the curve falls within some arbitrary limitations. The limitations should match the ones used by atrofac and armoury crate.

pub fn set_point(&mut self, n: u8, temp: u8, speed: u8)

Sets a point on the fan curve

Arguments

• n - The point on the fan curve to change, must be between 0 and 7 inclusive
• temp - Degrees celcius
• speed - Fan speed (see crate level documentation)

Panics

Panics if n isn’t in [0..=7]

pub fn apply(&self, board: Board, fan: Fan) -> Result<(), CurveError>

Applies the fan curve via acpi_call

Trait Implementations

impl Clone for Curve

fn clone(&self) -> Curve

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for Curve

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl<'de> Deserialize<'de> for Curve

fn deserialize<D>(deserializer: D) -> Result<Curve, D::Error> where
    D: Deserializer<'de>, 

Deserialize this value from the given Serde deserializer.

impl Serialize for Curve

fn serialize<S>(&self, serializer: S) -> Result<S::Ok, S::Error> where
    S: Serializer, 

Serialize this value into the given Serde serializer.