Struct probe_rs::cores::m33::M33

pub struct M33;

Trait Implementations

impl Clone for M33

fn clone(&self) -> M33

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Copy for M33

impl Core for M33

fn wait_for_core_halted(
    &self,
    mi: &mut MasterProbe
) -> Result<(), DebugProbeError>

Wait until the core is halted. If the core does not halt on its own, a [DebugProbeError::Timeout] error will be returned.

fn core_halted(&self, mi: &mut MasterProbe) -> Result<bool, DebugProbeError>

Check if the core is halted. If the core does not halt on its own, a [DebugProbeError::Timeout] error will be returned.

fn halt(&self, mi: &mut MasterProbe) -> Result<CoreInformation, DebugProbeError>

Try to halt the core. This function ensures the core is actually halted, and returns a [DebugProbeError::Timeout] otherwise.

fn run(&self, mi: &mut MasterProbe) -> Result<(), DebugProbeError>

fn reset(&self, mi: &mut MasterProbe) -> Result<(), DebugProbeError>

Reset the core, and then continue to execute instructions. If the core should be halted after reset, use the [reset_and_halt] function.

fn reset_and_halt(
    &self,
    mi: &mut MasterProbe
) -> Result<CoreInformation, DebugProbeError>

Reset the core, and then immediately halt. To continue execution after reset, use the [reset] function.

fn step(&self, mi: &mut MasterProbe) -> Result<CoreInformation, DebugProbeError>

Steps one instruction and then enters halted state again.

fn read_core_reg(
    &self,
    mi: &mut MasterProbe,
    addr: CoreRegisterAddress
) -> Result<u32, DebugProbeError>

fn write_core_reg(
    &self,
    mi: &mut MasterProbe,
    addr: CoreRegisterAddress,
    value: u32
) -> Result<(), DebugProbeError>

fn get_available_breakpoint_units(
    &self,
    mi: &mut MasterProbe
) -> Result<u32, DebugProbeError>

fn enable_breakpoints(
    &self,
    mi: &mut MasterProbe,
    state: bool
) -> Result<(), DebugProbeError>

fn set_breakpoint(
    &self,
    mi: &mut MasterProbe,
    bp_unit_index: usize,
    addr: u32
) -> Result<(), DebugProbeError>

fn read_block8(
    &self,
    mi: &mut MasterProbe,
    address: u32,
    data: &mut [u8]
) -> Result<(), DebugProbeError>

fn registers<'a>(&self) -> &'a BasicRegisterAddresses

fn clear_breakpoint(
    &self,
    mi: &mut MasterProbe,
    bp_unit_index: usize
) -> Result<(), DebugProbeError>

impl Debug for M33

fn fmt(&self, f: &mut Formatter) -> Result

Formats the value using the given formatter.

impl Default for M33

fn default() -> M33

Returns the "default value" for a type.