Enum nucleo_h7xx::pac::i2c1::cr2::PECBYTE_A [−]
Packet error checking byte This bit is set by software, and cleared by hardware when the PEC is transferred, or when a STOP condition or an Address matched is received, also when PE=0. Note: Writing 0 to this bit has no effect. This bit has no effect when RELOAD is set. This bit has no effect is slave mode when SBC=0. If the SMBus feature is not supported, this bit is reserved and forced by hardware to 0. Please refer to Section25.3: I2C implementation.
Value on reset: 0
Variants
0: No PEC transfer
1: PEC transmission/reception is requested
Trait Implementations
impl Clone for PECBYTE_A
pub fn clone(&self) -> PECBYTE_A
pub fn clone_from(&mut self, source: &Self)
1.0.0[src]
impl Copy for PECBYTE_A
impl Debug for PECBYTE_A
impl PartialEq<PECBYTE_A> for PECBYTE_A
pub fn eq(&self, other: &PECBYTE_A) -> bool
#[must_use]pub fn ne(&self, other: &Rhs) -> bool
1.0.0[src]
impl StructuralPartialEq for PECBYTE_A
Auto Trait Implementations
Blanket Implementations
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Borrow<T> for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut<T> for T where
T: ?Sized,
[src]
T: ?Sized,
pub fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> From<T> for T
[src]
impl<T, U> Into<U> for T where
U: From<T>,
[src]
U: From<T>,
impl<T> Same<T> for T
type Output = T
Should always be Self
impl<T, U> TryFrom<U> for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
pub fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T, U> TryInto<U> for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,