[−][src]Struct nrf52840_hal::target::saadc::RegisterBlock
Register block
Fields
tasks_start: TASKS_START
0x00 - Starts the SAADC and prepares the result buffer in RAM
tasks_sample: TASKS_SAMPLE
0x04 - Takes one SAADC sample
tasks_stop: TASKS_STOP
0x08 - Stops the SAADC and terminates all on-going conversions
tasks_calibrateoffset: TASKS_CALIBRATEOFFSET
0x0c - Starts offset auto-calibration
events_started: EVENTS_STARTED
0x100 - The SAADC has started
events_end: EVENTS_END
0x104 - The SAADC has filled up the result buffer
events_done: EVENTS_DONE
0x108 - A conversion task has been completed. Depending on the configuration, multiple conversions might be needed for a result to be transferred to RAM.
events_resultdone: EVENTS_RESULTDONE
0x10c - Result ready for transfer to RAM
events_calibratedone: EVENTS_CALIBRATEDONE
0x110 - Calibration is complete
events_stopped: EVENTS_STOPPED
0x114 - The SAADC has stopped
events_ch: [EVENTS_CH; 8]
0x118 - Unspecified
inten: INTEN
0x300 - Enable or disable interrupt
intenset: INTENSET
0x304 - Enable interrupt
intenclr: INTENCLR
0x308 - Disable interrupt
status: STATUS
0x400 - Status
enable: ENABLE
0x500 - Enable or disable SAADC
ch: [CH; 8]
0x510 - Unspecified
resolution: RESOLUTION
0x5f0 - Resolution configuration
oversample: OVERSAMPLE
0x5f4 - Oversampling configuration. The RESOLUTION is applied before averaging, thus for high OVERSAMPLE a higher RESOLUTION should be used.
samplerate: SAMPLERATE
0x5f8 - Controls normal or continuous sample rate
result: RESULT
0x62c - RESULT EasyDMA channel
Auto Trait Implementations
impl Send for RegisterBlock
impl !Sync for RegisterBlock
Blanket Implementations
impl<T, U> TryFrom for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T> From for T
[src]
impl<T, U> TryInto for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>
[src]
impl<T, U> Into for T where
U: From<T>,
[src]
U: From<T>,
impl<T> Borrow for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Same for T
type Output = T
Should always be Self