Struct nrf_softdevice_s122::ble_gap_opt_enable_evt_len_check_t

#[repr(C, packed(1))]
pub struct ble_gap_opt_enable_evt_len_check_t {
    pub _bitfield_1: __BindgenBitfieldUnit<[u8; 1], u8>,
}

@brief Enable event length checking.

When this option is enabled, the SoftDevice will prevent the application from switching to a state where the link can utilize more than the configured event length. See @ref ble_gap_conn_cfg_t::event_length. This validation is performed when the application calls the following APIs:

   - @ref sd_ble_gap_connect
   - @ref sd_ble_gap_phy_update

@note Event length checking is enabled by default.

@note For a link with an event length of @ref BLE_GAP_EVENT_LENGTH_2MBPS_PHY_MIN, the application cannot connect directly on 1Mbps unless @ref BLE_GAP_OPT_ENABLE_EVT_LEN_CHECK is disabled. The application is allowed to enable this option after the link has switched to 2Mbps.

@retval ::NRF_SUCCESS Set successfully.

Fields

_bitfield_1: __BindgenBitfieldUnit<[u8; 1], u8>

Implementations

impl ble_gap_opt_enable_evt_len_check_t

pub fn enable(&self) -> u8

pub fn set_enable(&mut self, val: u8)

pub fn new_bitfield_1(enable: u8) -> __BindgenBitfieldUnit<[u8; 1], u8>

Trait Implementations

impl Clone for ble_gap_opt_enable_evt_len_check_t

fn clone(&self) -> ble_gap_opt_enable_evt_len_check_t

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for ble_gap_opt_enable_evt_len_check_t

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Copy for ble_gap_opt_enable_evt_len_check_t