[−][src]Struct ncp5623c::NCP5623C
Methods
impl<I2C, CommE> NCP5623C<I2C> where
I2C: Write<Error = CommE> + Read<Error = CommE> + WriteRead<Error = CommE>,
[src]
I2C: Write<Error = CommE> + Read<Error = CommE> + WriteRead<Error = CommE>,
pub fn default(i2c_port: I2C) -> Result<Self, Error<CommE>>
[src]
pub fn new(i2c_port: I2C, address: u8) -> Result<Self, Error<CommE>>
[src]
pub fn reset(&mut self) -> Result<(), Error<CommE>>
[src]
pub fn set_brightness(&mut self, current: u8) -> Result<(), Error<CommE>>
[src]
You can use BRIGHTNESS_xxx constants here
pub fn set_register_bits(
&mut self,
reg: u8,
val: u8
) -> Result<(), Error<CommE>>
[src]
&mut self,
reg: u8,
val: u8
) -> Result<(), Error<CommE>>
This device has a single 8-bit register and provides "internal register bits" for writing. See datasheet "Internal Register Selection" and "Table 1. Internal Register Bits Assigment"
pub fn set_color_brightness(
&mut self,
bright: u8,
red: u8,
green: u8,
blue: u8
) -> Result<(), Error<CommE>>
[src]
&mut self,
bright: u8,
red: u8,
green: u8,
blue: u8
) -> Result<(), Error<CommE>>
Set the color and brightness values all at once
Auto Trait Implementations
impl<I2C> Send for NCP5623C<I2C> where
I2C: Send,
I2C: Send,
impl<I2C> Sync for NCP5623C<I2C> where
I2C: Sync,
I2C: Sync,
impl<I2C> Unpin for NCP5623C<I2C> where
I2C: Unpin,
I2C: Unpin,
Blanket Implementations
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Borrow<T> for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut<T> for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> From<T> for T
[src]
impl<T, U> Into<U> for T where
U: From<T>,
[src]
U: From<T>,
impl<T, U> TryFrom<U> for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T, U> TryInto<U> for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,