Struct lpc81x_pac::lpc811::sct0::ev::ev_ctrl::R

source ·

pub struct R(_);

Expand description

Register EV_CTRL reader

Implementations§

source §

impl R

source

pub fn matchsel(&self) -> MATCHSEL_R

Bits 0:3 - Selects the Match register associated with this event (if any). A match can occur only when the counter selected by the HEVENT bit is running.

source

pub fn hevent(&self) -> HEVENT_R

Bit 4 - Select L/H counter. Do not set this bit if UNIFY = 1.

source

pub fn outsel(&self) -> OUTSEL_R

Bit 5 - Input/output select

source

pub fn iosel(&self) -> IOSEL_R

Bits 6:9 - Selects the input or output signal number associated with this event (if any). Do not select an input in this register if CKMODE is 1x. In this case the clock input is an implicit ingredient of every event.

source

pub fn iocond(&self) -> IOCOND_R

Bits 10:11 - Selects the I/O condition for event n. (The detection of edges on outputs lag the conditions that switch the outputs by one SCT clock). In order to guarantee proper edge/state detection, an input must have a minimum pulse width of at least one SCT clock period .

source

pub fn combmode(&self) -> COMBMODE_R

Bits 12:13 - Selects how the specified match and I/O condition are used and combined.

source

pub fn stateld(&self) -> STATELD_R

Bit 14 - This bit controls how the STATEV value modifies the state selected by HEVENT when this event is the highest-numbered event occurring for that state.

source

pub fn statev(&self) -> STATEV_R

Bits 15:19 - This value is loaded into or added to the state selected by HEVENT, depending on STATELD, when this event is the highest-numbered event occurring for that state. If STATELD and STATEV are both zero, there is no change to the STATE value.

source

pub fn matchmem(&self) -> MATCHMEM_R

Bit 20 - If this bit is one and the COMBMODE field specifies a match component to the triggering of this event, then a match is considered to be active whenever the counter value is GREATER THAN OR EQUAL TO the value specified in the match register when counting up, LESS THEN OR EQUAL TO the match value when counting down. If this bit is zero, a match is only be active during the cycle when the counter is equal to the match value.

source

pub fn direction(&self) -> DIRECTION_R

Bits 21:22 - Direction qualifier for event generation. This field only applies when the counters are operating in BIDIR mode. If BIDIR = 0, the SCT ignores this field. Value 0x3 is reserved.