Struct lpc81x_pac::lpc810::pmu::dpdctrl::R

pub struct R(_);

Register DPDCTRL reader

Implementations

impl R

pub fn wakeuphys(&self) -> WAKEUPHYS_R

Bit 0 - WAKEUP pin hysteresis enable

pub fn wakepad_disable(&self) -> WAKEPAD_DISABLE_R

Bit 1 - WAKEUP pin disable. Setting this bit disables the wake-up pin, so it can be used for other purposes. Remark: Never set this bit if you intend to use a pin to wake up the part from Deep power-down mode. You can only disable the wake-up pin if the self wake-up timer is enabled and configured. Remark: Setting this bit is not necessary if Deep power-down mode is not used.

pub fn lposcen(&self) -> LPOSCEN_R

Bit 2 - Enable the low-power oscillator for use with the 10 kHz self wake-up timer clock. You must set this bit if the CLKSEL bit in the self wake-up timer CTRL bit is set. Do not enable the low-power oscillator if the self wake-up timer is clocked by the divided IRC or the external clock input.

pub fn lposcdpden(&self) -> LPOSCDPDEN_R

Bit 3 - causes the low-power oscillator to remain running during Deep power-down mode provided that bit 2 in this register is set as well. You must set this bit for the self wake-up timer to be able to wake up the part from Deep power-down mode. Remark: Do not set this bit unless you use the self wake-up timer with the low-power oscillator clock source to wake up from Deep power-down mode.

pub fn gpdata(&self) -> GPDATA_R

Bits 4:31 - Data retained during Deep power-down mode.

Methods from Deref<Target = R<DPDCTRL_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<DPDCTRL_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<DPDCTRL_SPEC>> for R

fn from(reader: R<DPDCTRL_SPEC>) -> Self

Converts to this type from the input type.