Struct lpc81x_pac::pmu::dpdctrl::W

pub struct W { /* fields omitted */ }

Value to write to the register

Methods

impl W

pub fn reset_value() -> W

Reset value of the register

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register

pub fn wakeuphys(&mut self) -> _WAKEUPHYSW

Bit 0 - WAKEUP pin hysteresis enable

pub fn wakepad_disable(&mut self) -> _WAKEPAD_DISABLEW

Bit 1 - WAKEUP pin disable. Setting this bit disables the wake-up pin, so it can be used for other purposes. Never set this bit if you intend to use a pin to wake up the part from Deep power-down mode. You can only disable the wake-up pin if the self wake-up timer is enabled and configured. Setting this bit is not necessary if Deep power-down mode is not used.

pub fn lposcen(&mut self) -> _LPOSCENW

Bit 2 - Enable the low-power oscillator for use with the 10 kHz self wake-up timer clock. You must set this bit if the CLKSEL bit in the self wake-up timer CTRL bit is set. Do not enable the low-power oscillator if the self wake-up timer is clocked by the divided IRC.

pub fn lposcdpden(&mut self) -> _LPOSCDPDENW

Bit 3 - Enable the low-power oscillator in Deep power-down mode. Setting this bit causes the low-power oscillator to remain running during Deep power-down mode provided that bit 12 in this register is set as well. You must set this bit for the self wake-up timer to be able to wake up the part from Deep power-down mode. Do not set this bit unless you must use the self wake-up timer to wake up from Deep power-down mode.