Struct lpc81x_pac::cmp::ctrl::W

pub struct W { /* fields omitted */ }

Value to write to the register

Methods

impl W

pub fn reset_value() -> W

Reset value of the register

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register

pub fn edgesel(&mut self) -> _EDGESELW

Bits 3:4 - This field controls which edges on the comparator output set the COMPEDGE bit (bit 23 below): 00 = Falling edges 01 = Rising edges 1x = Both edges

pub fn compsa(&mut self) -> _COMPSAW

Bit 6 - Comparator output control

pub fn comp_vp_sel(&mut self) -> _COMP_VP_SELW

Bits 8:10 - Selects positive voltage input

pub fn comp_vm_sel(&mut self) -> _COMP_VM_SELW

Bits 11:13 - Selects negative voltage input

pub fn edgeclr(&mut self) -> _EDGECLRW

Bit 20 - Interrupt clear bit. To clear the COMPEDGE bit and thus negate the interrupt request, toggle the EDGECLR bit by first writing a 1 and then a 0.

pub fn compstat(&mut self) -> _COMPSTATW

Bit 21 - Comparator status. This bit reflects the state of the comparator output.

pub fn compedge(&mut self) -> _COMPEDGEW

Bit 23 - Comparator edge-detect status.

pub fn hys(&mut self) -> _HYSW

Bits 25:26 - Controls the hysteresis of the comparator. When the comparator is outputting a certain state, this is the difference between the selected signals, in the opposite direction from the state being output, that will switch the output.