Crate ld06_embed

This crate is an embedded_hal peripheral driver for the LD06/LD09 drivers sold under various brands.

Setup

To use this crate, simply connect to the LD06 UART via an interface of your choice, then pass that interface to the LD06 struct found in this crate. Note that it seems the LiDAR needs a PWM signal for motor control as it has a PWM pin, but in my experience this has not been the case. Nonetheless, I have provided a wrapper struct that also provides PID control for this signal, should it be needed for your use case.

Example

(see here for runnable example on linux)

 let mut ld06 = LD06::new(serial);

 loop {
     match ld06.read_next_byte() {
         Ok(None) => {}
         Err(err) => match err {
             Error::Other(parse_err) => match parse_err {
                 ParseError::SerialErr(_) => {
                     println!("Serial issue")
                 }
                 ParseError::CrcFail => {
                     println!("CRC failed")
                 }
             },
             Error::WouldBlock => {
                 println!("Would block")
             }
         },
         Ok(Some(scan)) => {
             println!("scan: {:?}", scan);
         }
     }
 }

Re-exports

pub use nb;

Modules

error

Structs

LD06

An LD06 Peripheral.

LD06Pid

LD06 peripheral driver that includes PID control for the motor.

PartialScan

A single scan packet from the Lidar.

Range

A range reading from the sensor.