Crate hc14_at_rs

HC-14 driver This driver implements normal, config and sleep functionality of the hc12 module.

When the Key pin is pulled low, you can configure the module using AT commands. This driver program receives output pins, a serial port, and a delay time from embedded-hal and provides a convenient interface to interact with the HC-14 module.

The HC-14 can operate in two modes: Normal mode and AT configuration mode.

For more details, refer to the official documentation available here.

Building upon the barafael/hc12-at-rs project, this driver has been restructured for the HC-14 module. It’s worth noting that, compared to the HC-12, the HC-14 module has additional features. However, the documentation only provides an overview of the module, and there are no example programs. As of now, I have tested this driver using an STM32F103 with default settings. In an urban environment, with the transmitting module placed on the 7th floor, the communication range is approximately 600-700 meters.

当 Key 引脚被拉低时，可以使用 AT 指令对该模块进行配置。该驱动程序从 embedded-hal 中获取输出引脚、 串行端口和延迟时间，提供了一个与 hc14 模块交互的简便接口。

HC-14 的运行状态：正常模式、AT配置配置。

更多详情，请参阅此处提供的官方文档，

在barafael/hc12-at-rs基础上对hc14模块进行重构，不得不说，相比hc12， hc14模块被很多功能有没有了，文档对模块的介绍也就停留在介绍而已，例程也没有，我暂时只使用了STM32F103进行了测试，使用默认设置， 在城市中，发送模块放在7楼的情况下，通信距离大约：600-700米的。

Example

let hc14 = Hc14::new(serial, key, delay).unwrap();

 // Reset mode parameters
 let mut hc14_configure = hc14.into_configuration_mode().unwrap();
 hc14_configure.reset_settings();
 
 // Retrieve Hc14 parameters
 hc14_configure.get_parameters().unwrap();
 
 // Set channel
 let mut buffer = [0u8; 32];
 hc14_configure.wirte_set_channel(28, &mut buffer);
 
 // Switch to normal mode
 let mut hc14_normal = hc14_configure.into_normal_mode().unwrap();
 
 // Send buffer
 let buf = b"hc14";
 hc14_normal.send_buffer(buf).unwrap();
 
 // Send a string
 let buf_str = "hc14";
 hc14_normal.send_string(buf_str);

Modules

• conf
  HC-14 指令集(Instruction Set)
• driver
  HC-14 驱动程序(Driver)
• setting
  HC-14 Settings

Enums

• Error
  Crate 错误(Error)