Struct gd32vf103_pac::i2c0::ctl0::W

pub struct W(_);

Register CTL0 writer

Implementations

impl W

pub fn i2cen(&mut self) -> I2CEN_W<'_, 0>

Bit 0 - I2C peripheral enable

pub fn smben(&mut self) -> SMBEN_W<'_, 1>

Bit 1 - SMBus/I2C mode switch

pub fn smbsel(&mut self) -> SMBSEL_W<'_, 3>

Bit 3 - SMBusType Selection

pub fn arpen(&mut self) -> ARPEN_W<'_, 4>

Bit 4 - ARP protocol in SMBus switch

pub fn pecen(&mut self) -> PECEN_W<'_, 5>

Bit 5 - PEC Calculation Switch

pub fn gcen(&mut self) -> GCEN_W<'_, 6>

Bit 6 - Whether or not to response to a General Call (0x00)

pub fn ss(&mut self) -> SS_W<'_, 7>

Bit 7 - Whether to stretch SCL low when data is not ready in slave mode

pub fn start(&mut self) -> START_W<'_, 8>

Bit 8 - Generate a START condition on I2C bus

pub fn stop(&mut self) -> STOP_W<'_, 9>

Bit 9 - Generate a STOP condition on I2C bus

pub fn acken(&mut self) -> ACKEN_W<'_, 10>

Bit 10 - Whether or not to send an ACK

pub fn poap(&mut self) -> POAP_W<'_, 11>

Bit 11 - Position of ACK and PEC when receiving

pub fn pectrans(&mut self) -> PECTRANS_W<'_, 12>

Bit 12 - PEC Transfer

pub fn salt(&mut self) -> SALT_W<'_, 13>

Bit 13 - SMBus alert

pub fn sreset(&mut self) -> SRESET_W<'_, 15>

Bit 15 - Software reset

pub unsafe fn bits(&mut self, bits: u16) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<CTL0_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Safety

Read datasheet or reference manual to find what values are allowed to pass.

Trait Implementations

impl Deref for W

type Target = W<CTL0_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<CTL0_SPEC>> for W

fn from(writer: W<CTL0_SPEC>) -> Self

Converts to this type from the input type.