Struct gd32vf103_pac::i2c0::ctl0::R

pub struct R(_);

Register CTL0 reader

Implementations

impl R

pub fn i2cen(&self) -> I2CEN_R

Bit 0 - I2C peripheral enable

pub fn smben(&self) -> SMBEN_R

Bit 1 - SMBus/I2C mode switch

pub fn smbsel(&self) -> SMBSEL_R

Bit 3 - SMBusType Selection

pub fn arpen(&self) -> ARPEN_R

Bit 4 - ARP protocol in SMBus switch

pub fn pecen(&self) -> PECEN_R

Bit 5 - PEC Calculation Switch

pub fn gcen(&self) -> GCEN_R

Bit 6 - Whether or not to response to a General Call (0x00)

pub fn ss(&self) -> SS_R

Bit 7 - Whether to stretch SCL low when data is not ready in slave mode

pub fn start(&self) -> START_R

Bit 8 - Generate a START condition on I2C bus

pub fn stop(&self) -> STOP_R

Bit 9 - Generate a STOP condition on I2C bus

pub fn acken(&self) -> ACKEN_R

Bit 10 - Whether or not to send an ACK

pub fn poap(&self) -> POAP_R

Bit 11 - Position of ACK and PEC when receiving

pub fn pectrans(&self) -> PECTRANS_R

Bit 12 - PEC Transfer

pub fn salt(&self) -> SALT_R

Bit 13 - SMBus alert

pub fn sreset(&self) -> SRESET_R

Bit 15 - Software reset

Methods from Deref<Target = R<CTL0_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<CTL0_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<CTL0_SPEC>> for R

fn from(reader: R<CTL0_SPEC>) -> Self

Converts to this type from the input type.