Enum fann::TrainAlgorithm
[−]
[src]
pub enum TrainAlgorithm { Incremental(IncrementalParams), Batch(BatchParams), Rprop(RpropParams), Quickprop(QuickpropParams), }
The Training algorithms used when training on fann_train_data
with functions like
fann_train_on_data
or fann_train_on_file
. The incremental training alters the weights
after each time it is presented an input pattern, while batch only alters the weights once after
it has been presented to all the patterns.
Variants
Incremental(IncrementalParams)
Standard backpropagation algorithm, where the weights are updated after each training pattern. This means that the weights are updated many times during a single epoch and some problems will train very fast, while other more advanced problems will not train very well.
Batch(BatchParams)
Standard backpropagation algorithm, where the weights are updated after calculating the mean square error for the whole training set. This means that the weights are only updated once during an epoch. For this reason some problems will train slower with this algorithm. But since the mean square error is calculated more correctly than in incremental training, some problems will reach better solutions.
Rprop(RpropParams)
A more advanced batch training algorithm which achieves good results for many problems.
Rprop
is adaptive and therefore does not use the learning_rate
. Some other parameters
can, however, be set to change the way Rprop
works, but it is only recommended for users
with a deep understanding of the algorithm. The original RPROP training algorithm is
described by [Riedmiller and Braun, 1993], but the algorithm used here is a variant, iRPROP,
described by [Igel and Husken, 2000].
Quickprop(QuickpropParams)
A more advanced batch training algorithm which achieves good results for many problems. The
quickprop training algorithm uses the learning_rate
parameter along with other more
advanced parameters, but it is only recommended to change these for users with a deep
understanding of the algorithm. Quickprop is described by [Fahlman, 1988].
Trait Implementations
impl Copy for TrainAlgorithm
[src]
impl Clone for TrainAlgorithm
[src]
fn clone(&self) -> TrainAlgorithm
Returns a copy of the value. Read more
fn clone_from(&mut self, source: &Self)
1.0.0
Performs copy-assignment from source
. Read more
impl Debug for TrainAlgorithm
[src]
impl PartialEq for TrainAlgorithm
[src]
fn eq(&self, __arg_0: &TrainAlgorithm) -> bool
This method tests for self
and other
values to be equal, and is used by ==
. Read more
fn ne(&self, __arg_0: &TrainAlgorithm) -> bool
This method tests for !=
.
impl Default for TrainAlgorithm
[src]
fn default() -> TrainAlgorithm
Returns the "default value" for a type. Read more