Module bmod

Burst mode transfer configuration register

Structs

BMOD_SPEC

Burst mode transfer configuration register

Type Aliases

DE_R

Field DE reader - IDMAC Enable. When set, the IDMAC is enabled.

DE_W

Field DE writer - IDMAC Enable. When set, the IDMAC is enabled.

FB_R

Field FB reader - Fixed Burst. Controls whether the AHB Master interface performs fixed burst transfers or not. When set, the AHB will use only SINGLE, INCR4, INCR8 or INCR16 during start of normal burst transfers. When reset, the AHB will use SINGLE and INCR burst transfer operations.

FB_W

Field FB writer - Fixed Burst. Controls whether the AHB Master interface performs fixed burst transfers or not. When set, the AHB will use only SINGLE, INCR4, INCR8 or INCR16 during start of normal burst transfers. When reset, the AHB will use SINGLE and INCR burst transfer operations.

PBL_R

Field PBL reader - Programmable Burst Length. These bits indicate the maximum number of beats to be performed in one IDMAC???Internal DMA Control???transaction. The IDMAC will always attempt to burst as specified in PBL each time it starts a burst transfer on the host bus. The permissible values are 1, 4, 8, 16, 32, 64, 128 and 256. This value is the mirror of MSIZE of FIFOTH register. In order to change this value, write the required value to FIFOTH register. This is an encode value as follows: 000: 1-byte transfer; 001: 4-byte transfer; 010: 8-byte transfer; 011: 16-byte transfer; 100: 32-byte transfer; 101: 64-byte transfer; 110: 128-byte transfer; 111: 256-byte transfer. PBL is a read-only value and is applicable only for data access, it does not apply to descriptor access.

PBL_W

Field PBL writer - Programmable Burst Length. These bits indicate the maximum number of beats to be performed in one IDMAC???Internal DMA Control???transaction. The IDMAC will always attempt to burst as specified in PBL each time it starts a burst transfer on the host bus. The permissible values are 1, 4, 8, 16, 32, 64, 128 and 256. This value is the mirror of MSIZE of FIFOTH register. In order to change this value, write the required value to FIFOTH register. This is an encode value as follows: 000: 1-byte transfer; 001: 4-byte transfer; 010: 8-byte transfer; 011: 16-byte transfer; 100: 32-byte transfer; 101: 64-byte transfer; 110: 128-byte transfer; 111: 256-byte transfer. PBL is a read-only value and is applicable only for data access, it does not apply to descriptor access.

R

Register BMOD reader

SWR_R

Field SWR reader - Software Reset. When set, the DMA Controller resets all its internal registers. It is automatically cleared after one clock cycle.

SWR_W

Field SWR writer - Software Reset. When set, the DMA Controller resets all its internal registers. It is automatically cleared after one clock cycle.

W

Register BMOD writer