Type Definition esp32::uart::uart_rs485_conf_reg::W

type W = W<u32, UART_RS485_CONF_REG>;

Writer for register UART_RS485_CONF_REG

Methods

impl W

pub fn uart_rs485_tx_dly_num(&mut self) -> UART_RS485_TX_DLY_NUM_W

Bits 6:9 - This register is used to delay the transmitter's internal data signal.

pub fn uart_rs485_rx_dly_num(&mut self) -> UART_RS485_RX_DLY_NUM_W

Bit 5 - This register is used to delay the receiver's internal data signal.

pub fn uart_rs485rxby_tx_en(&mut self) -> UART_RS485RXBY_TX_EN_W

Bit 4 - 1: enable rs485's transmitter to send data when rs485's receiver is busy. 0:rs485's transmitter should not send data when its receiver is busy.

pub fn uart_rs485tx_rx_en(&mut self) -> UART_RS485TX_RX_EN_W

Bit 3 - Set this bit to enable loopback transmitter's output data signal to receiver's input data signal.

pub fn uart_dl1_en(&mut self) -> UART_DL1_EN_W

Bit 2 - Set this bit to delay the stop bit by 1 bit.

pub fn uart_dl0_en(&mut self) -> UART_DL0_EN_W

Bit 1 - Set this bit to delay the stop bit by 1 bit.

pub fn uart_rs485_en(&mut self) -> UART_RS485_EN_W

Bit 0 - Set this bit to choose rs485 mode.