Struct efm32gg11b_pac::efm32gg11b840::sdio::hostctrl1::W

pub struct W(_);

Register HOSTCTRL1 writer

Implementations

impl W

pub fn ledctrl(&mut self) -> LEDCTRL_W<'_, 0>

Bit 0 - LED Control

pub fn dattranwd(&mut self) -> DATTRANWD_W<'_, 1>

Bit 1 - Data Transfer Width 1-bit or 4-bit Mode

pub fn hsen(&mut self) -> HSEN_W<'_, 2>

Bit 2 - High Speed Enable

pub fn dmasel(&mut self) -> DMASEL_W<'_, 3>

Bits 3:4 - DMA Select

pub fn extdattranwd(&mut self) -> EXTDATTRANWD_W<'_, 5>

Bit 5 - Extended Data Transfer Width

pub fn cdtstlvl(&mut self) -> CDTSTLVL_W<'_, 6>

Bit 6 - Card Detect Test Level

pub fn cdsigdet(&mut self) -> CDSIGDET_W<'_, 7>

Bit 7 - Card Detetct Signal Detection

pub fn sdbuspower(&mut self) -> SDBUSPOWER_W<'_, 8>

Bit 8 - SD Bus Power

pub fn sdbusvoltsel(&mut self) -> SDBUSVOLTSEL_W<'_, 9>

Bits 9:11 - SD Bus Voltage Select

pub fn hrdrst(&mut self) -> HRDRST_W<'_, 12>

Bit 12 - Hardware Reset Signal

pub fn stopatblkgapreq(&mut self) -> STOPATBLKGAPREQ_W<'_, 16>

Bit 16 - Stop at Block Gap Request

pub fn continuereq(&mut self) -> CONTINUEREQ_W<'_, 17>

Bit 17 - Continue Request

pub fn rdwaitctrl(&mut self) -> RDWAITCTRL_W<'_, 18>

Bit 18 - Read Wait Control

pub fn intatblkgap(&mut self) -> INTATBLKGAP_W<'_, 19>

Bit 19 - Interrupt at Block Gap

pub fn spimode(&mut self) -> SPIMODE_W<'_, 20>

Bit 20 - SPI Mode Enable

pub fn booten(&mut self) -> BOOTEN_W<'_, 21>

Bit 21 - Boot Enable

pub fn altbooten(&mut self) -> ALTBOOTEN_W<'_, 22>

Bit 22 - Alternate Boot Enable

pub fn bootackchk(&mut self) -> BOOTACKCHK_W<'_, 23>

Bit 23 - Boot Ack Check

pub fn wkupevntenoncardint(&mut self) -> WKUPEVNTENONCARDINT_W<'_, 24>

Bit 24 - Wakeup Event Enable on Card Interrupt

pub fn wkupevntenoncins(&mut self) -> WKUPEVNTENONCINS_W<'_, 25>

Bit 25 - Wakeup Event Enable on SD Card Insertion

pub fn wkupevntenoncrm(&mut self) -> WKUPEVNTENONCRM_W<'_, 26>

Bit 26 - Wakeup Event Enable on SD Card Removal

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<HOSTCTRL1_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Safety

Read datasheet or reference manual to find what values are allowed to pass.

Trait Implementations

impl Deref for W

type Target = W<HOSTCTRL1_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<HOSTCTRL1_SPEC>> for W

fn from(writer: W<HOSTCTRL1_SPEC>) -> Self

Converts to this type from the input type.