Struct efm32gg11b_pac::efm32gg11b840::eth::networkctrl::R

pub struct R(_);

Register NETWORKCTRL reader

Implementations

impl R

pub fn loopbacklocal(&self) -> LOOPBACKLOCAL_R

Bit 1 - Loopback local

pub fn enbrx(&self) -> ENBRX_R

Bit 2 - Receive enable

pub fn enbtx(&self) -> ENBTX_R

Bit 3 - Transmit enable

pub fn manporten(&self) -> MANPORTEN_R

Bit 4 - Management port enable

pub fn clrallstatsregs(&self) -> CLRALLSTATSREGS_R

Bit 5 - Clear statistics registers

pub fn incallstatsregs(&self) -> INCALLSTATSREGS_R

Bit 6 - Incremental statistics registers

pub fn statswren(&self) -> STATSWREN_R

Bit 7 - Write enable for statistics registers

pub fn backpressure(&self) -> BACKPRESSURE_R

Bit 8 - Back pressure will force collisions on all received frames

pub fn txstrt(&self) -> TXSTRT_R

Bit 9 - Start transmission

pub fn txhalt(&self) -> TXHALT_R

Bit 10 - Transmit halt

pub fn txpfrmreq(&self) -> TXPFRMREQ_R

Bit 11 - Transmit pause frame

pub fn txpfrmzero(&self) -> TXPFRMZERO_R

Bit 12 - Transmit zero quantum pause frame

pub fn storerxts(&self) -> STORERXTS_R

Bit 15 - Store receive time stamp to memory.

pub fn pfcenb(&self) -> PFCENB_R

Bit 16 - Enable PFC Priority Based Pause Reception capabilities.

pub fn txpfcpriorpfrm(&self) -> TXPFCPRIORPFRM_R

Bit 17 - Write a one to transmit PFC priority based pause frame.

pub fn flushrxpkt(&self) -> FLUSHRXPKT_R

Bit 18 - Flush the next packet from the external RX DPRAM.

pub fn txlpien(&self) -> TXLPIEN_R

Bit 19 - Enable LPI transmission when set LPI (low power idle) is immediately transmitted.

pub fn ptpunicasten(&self) -> PTPUNICASTEN_R

Bit 20 - Enable detection of unicast PTP unicast frames.

pub fn storeudpoffset(&self) -> STOREUDPOFFSET_R

Bit 22 - Store UDP / TCP offset to memory.

pub fn onestepsyncmode(&self) -> ONESTEPSYNCMODE_R

Bit 24 - 1588 One Step Sync Mode.

pub fn pfcctrl(&self) -> PFCCTRL_R

Bit 25 - Enable multiple PFC pause quantums, one per pause priority

Methods from Deref<Target = R<NETWORKCTRL_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<NETWORKCTRL_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<NETWORKCTRL_SPEC>> for R

fn from(reader: R<NETWORKCTRL_SPEC>) -> Self

Converts to this type from the input type.