Struct efm32gg11b_pac::efm32gg11b110::usart3::ctrl::R

pub struct R(_);

Register CTRL reader

Implementations

impl R

pub fn sync(&self) -> SYNC_R

Bit 0 - USART Synchronous Mode

pub fn loopbk(&self) -> LOOPBK_R

Bit 1 - Loopback Enable

pub fn ccen(&self) -> CCEN_R

Bit 2 - Collision Check Enable

pub fn mpm(&self) -> MPM_R

Bit 3 - Multi-Processor Mode

pub fn mpab(&self) -> MPAB_R

Bit 4 - Multi-Processor Address-Bit

pub fn ovs(&self) -> OVS_R

Bits 5:6 - Oversampling

pub fn clkpol(&self) -> CLKPOL_R

Bit 8 - Clock Polarity

pub fn clkpha(&self) -> CLKPHA_R

Bit 9 - Clock Edge for Setup/Sample

pub fn msbf(&self) -> MSBF_R

Bit 10 - Most Significant Bit First

pub fn csma(&self) -> CSMA_R

Bit 11 - Action on Slave-Select in Master Mode

pub fn txbil(&self) -> TXBIL_R

Bit 12 - TX Buffer Interrupt Level

pub fn rxinv(&self) -> RXINV_R

Bit 13 - Receiver Input Invert

pub fn txinv(&self) -> TXINV_R

Bit 14 - Transmitter Output Invert

pub fn csinv(&self) -> CSINV_R

Bit 15 - Chip Select Invert

pub fn autocs(&self) -> AUTOCS_R

Bit 16 - Automatic Chip Select

pub fn autotri(&self) -> AUTOTRI_R

Bit 17 - Automatic TX Tristate

pub fn scmode(&self) -> SCMODE_R

Bit 18 - SmartCard Mode

pub fn scretrans(&self) -> SCRETRANS_R

Bit 19 - SmartCard Retransmit

pub fn skipperrf(&self) -> SKIPPERRF_R

Bit 20 - Skip Parity Error Frames

pub fn bit8dv(&self) -> BIT8DV_R

Bit 21 - Bit 8 Default Value

pub fn errsdma(&self) -> ERRSDMA_R

Bit 22 - Halt DMA on Error

pub fn errsrx(&self) -> ERRSRX_R

Bit 23 - Disable RX on Error

pub fn errstx(&self) -> ERRSTX_R

Bit 24 - Disable TX on Error

pub fn sssearly(&self) -> SSSEARLY_R

Bit 25 - Synchronous Slave Setup Early

pub fn byteswap(&self) -> BYTESWAP_R

Bit 28 - Byteswap in Double Accesses

pub fn autotx(&self) -> AUTOTX_R

Bit 29 - Always Transmit When RX Not Full

pub fn mvdis(&self) -> MVDIS_R

Bit 30 - Majority Vote Disable

pub fn smsdelay(&self) -> SMSDELAY_R

Bit 31 - Synchronous Master Sample Delay

Methods from Deref<Target = R<CTRL_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<CTRL_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<CTRL_SPEC>> for R

fn from(reader: R<CTRL_SPEC>) -> Self

Converts to this type from the input type.