[−][src]Struct stm32l0xx_hal::pwr::StopMode

pub struct StopMode<'r> { /* fields omitted */ }

Stop mode

You can get an instance of this struct by calling PWR::stop_mode.

The PowerMode implementation of this type will block until something wakes the microcontroller up again. Please make sure to configure an interrupt, or it could block forever.

This method will always disable the internal voltage regulator during Stop mode.

Please note that entering Stop mode may change the SCB configuration.

Panics

Panics, if the external clock is selected as clock source. In principle, it is possible to enter Stop mode with the external clock enabled, although that might require special handling. This is explained in the STM32L0x2 Reference Manual, section 6.3.9.

Trait Implementations

impl<'_> PowerMode for StopMode<'_>[src]

Auto Trait Implementations

impl<'r> Unpin for StopMode<'r>

impl<'r> Send for StopMode<'r>

impl<'r> !Sync for StopMode<'r>

Blanket Implementations

impl<T> From<T> for T[src]

impl<T, U> TryFrom<U> for T where
    U: Into<T>, [src]

type Error = !

The type returned in the event of a conversion error.

impl<T, U> Into<U> for T where
    U: From<T>, [src]

impl<T, U> TryInto<U> for T where
    U: TryFrom<T>, [src]

type Error = <U as TryFrom<T>>::Error

The type returned in the event of a conversion error.

impl<T> Borrow<T> for T where
    T: ?Sized, [src]

impl<T> BorrowMut<T> for T where
    T: ?Sized, [src]

impl<T> Any for T where
    T: 'static + ?Sized, [src]

impl<T> Same<T> for T

type Output = T

Should always be Self