Struct stm32_usbd::bus::UsbBus

pub struct UsbBus { /* fields omitted */ }

USB peripheral driver for STM32 microcontrollers.

Methods

impl UsbBus

pub fn usb(regs: USB) -> UsbBusAllocator<Self>

Constructs a new USB peripheral driver.

pub fn usb_with_reset(
    regs: USB,
    clocks: &Clocks,
    reset_pin: ResetPin
) -> UsbBusAllocator<Self>

Constructs a new USB peripheral driver with the "reset" method enabled.

Trait Implementations

impl UsbBus for UsbBus

fn alloc_ep(
    &mut self,
    ep_dir: UsbDirection,
    ep_addr: Option<EndpointAddress>,
    ep_type: EndpointType,
    max_packet_size: u16,
    _interval: u8
) -> Result<EndpointAddress>

Allocates an endpoint and specified endpoint parameters. This method is called by the device and class implementations to allocate endpoints, and can only be called before enable is called.

fn enable(&mut self)

Enables and initializes the USB peripheral. Soon after enabling the device will be reset, so there is no need to perform a USB reset in this method.

fn reset(&self)

Performs a USB reset. This method should reset the platform-specific peripheral as well as ensure that all endpoints previously allocate with alloc_ep are initialized as specified.

fn set_device_address(&self, addr: u8)

Sets the device USB address to addr.

fn poll(&self) -> PollResult

Gets information about events and incoming data. Usually called in a loop or from an interrupt handler. See the [PollResult] struct for more information.

fn write(&self, ep_addr: EndpointAddress, buf: &[u8]) -> Result<usize>

Writes a single packet of data to the specified endpoint and returns number of bytes actually written.

fn read(&self, ep_addr: EndpointAddress, buf: &mut [u8]) -> Result<usize>

Reads a single packet of data from the specified endpoint and returns the actual length of the packet.

fn set_stalled(&self, ep_addr: EndpointAddress, stalled: bool)

Sets or clears the STALL condition for an endpoint. If the endpoint is an OUT endpoint, it should be prepared to receive data again.

fn is_stalled(&self, ep_addr: EndpointAddress) -> bool

Gets whether the STALL condition is set for an endpoint.

fn suspend(&self)

Causes the USB peripheral to enter USB suspend mode, lowering power consumption and preparing to detect a USB wakeup event. This will be called after poll returns [PollResult::Suspend]. The device will continue be polled, and it shall return a value other than Suspend from poll when it no longer detects the suspend condition.

fn resume(&self)

Resumes from suspend mode. This may only be called after the peripheral has been previously suspended.

fn force_reset(&self) -> Result<()>

Simulates a disconnect from the USB bus, causing the host to reset and re-enumerate the device.