stellaris-launchpad-0.7.0 doesn't have any documentation.
Rust on the Stellaris Launchpad
A bare metal example program written in Rust (https://rust-lang.org) for the Stellaris Launchpad (LM4F120 dev board). May also work on the very closely related Tiva-C TM4C120 Launchpad.
The idea is that useful functionality will be moved out into separate crates.
Requirements
- rustc nightly
- xargo
- arm-none-eabi-gcc
- arm-none-eabi-ar
- arm-none-eabi-objcopy
Geting set up
Compile and upload
You can also debug
~/launchpad-rs $ sudo openocd -f /usr/share/openocd/scripts/board/ek-lm4f120xl.cfg
~/launchpad-rs $ arm-none-eabi-gdb ./target/thumbv7em-none-eabihf/debug/examples/launchpad_blink
(gdb) target remote localhost:3333
(gdb) load
Loading section .text, size 0x1e98 lma 0x0
Loading section .ARM.exidx, size 0x8 lma 0x1e98
Loading section .data, size 0xc lma 0x1ea0
Start address 0x0, load size 7852
Transfer rate: 7 KB/sec, 2617 bytes/write.
(gdb) monitor reset halt
(gdb) break main
(gdb) continue
What works:
- UART works, using the on-board UART-to-USB bridge (115200 bps, 8N1)
- PLL runs at 66.7MHz
- SysTick works at 4MHz, providing a timer a currently use for the busy-waits
- GPIO works - you can control the on-board RGB LED
- Timer works - you can drive GPIOs (including the LED) with PWM
- Panic handler works - it quickly flashes the red LED if it panics or hits a hardfault