Struct qn908x_rs::bledp::dp_top_system_ctrl::W
[−]
[src]
pub struct W { /* fields omitted */ }
Value to write to the register
Methods
impl W
[src]
pub fn reset_value() -> W
[src]
Reset value of the register
pub unsafe fn bits(&mut self, bits: u32) -> &mut Self
[src]
Writes raw bits to the register
pub fn rx_pdu_len_in(&mut self) -> _RX_PDU_LEN_INW
[src]
Bits 0:13 - pdu length user programmed header+payload unit is bit.
pub fn aa_sel(&mut self) -> _AA_SELW
[src]
Bit 14 - access address selection
pub fn pdu_len_sel(&mut self) -> _PDU_LEN_SELW
[src]
Bit 15 - pdu length selection
pub fn h_idx(&mut self) -> _H_IDXW
[src]
Bits 16:23 - h index from 0.25 to 0.75 default is 0.5.
pub fn rx_en_sel(&mut self) -> _RX_EN_SELW
[src]
Bit 24 - rx enable select signal
pub fn tx_en_sel(&mut self) -> _TX_EN_SELW
[src]
Bit 25 - tx enable select signal
pub fn rx_req(&mut self) -> _RX_REQW
[src]
Bit 26 - rx request.
pub fn tx_req(&mut self) -> _TX_REQW
[src]
Bit 27 - tx request.
pub fn rx_mode(&mut self) -> _RX_MODEW
[src]
Bits 28:29 - rx mode
pub fn ant_data_start(&mut self) -> _ANT_DATA_STARTW
[src]
Bit 30 - ant mode data start signal need write 0 first then to 1.
pub fn det_mode(&mut self) -> _DET_MODEW
[src]
Bit 31 - detection mode 0low ppwer mode 1high performance mode.