[−][src]Struct nrf52840_hal::target::power::pofcon::W
Value to write to the register
Methods
impl W[src]
pub fn reset_value() -> W[src]
Reset value of the register
pub unsafe fn bits(&mut self, bits: u32) -> &mut W[src]
Writes raw bits to the register
pub fn pof(&mut self) -> _POFW[src]
Bit 0 - Enable or disable power failure warning
pub fn threshold(&mut self) -> _THRESHOLDW[src]
Bits 1:4 - Power-fail comparator threshold setting. This setting applies both for normal voltage mode (supply connected to both VDD and VDDH) and high voltage mode (supply connected to VDDH only). Values 0-3 set threshold below 1.7 V and should not be used as brown out detection will be activated before power failure warning on such low voltages.
pub fn thresholdvddh(&mut self) -> _THRESHOLDVDDHW[src]
Bits 8:11 - Power-fail comparator threshold setting for high voltage mode (supply connected to VDDH only). This setting does not apply for normal voltage mode (supply connected to both VDD and VDDH).
Auto Trait Implementations
Blanket Implementations
impl<T> From for T[src]
impl<T, U> TryFrom for T where
U: Into<T>, [src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>[src]
impl<T, U> TryInto for T where
U: TryFrom<T>, [src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>[src]
impl<T, U> Into for T where
U: From<T>, [src]
U: From<T>,
impl<T> Borrow for T where
T: ?Sized, [src]
T: ?Sized,
impl<T> BorrowMut for T where
T: ?Sized, [src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T[src]
impl<T> Any for T where
T: 'static + ?Sized, [src]
T: 'static + ?Sized,
impl<T> Same for T
type Output = T
Should always be Self