Struct nrf52832_hal::Spim

pub struct Spim<T>(_);

Interface to a SPIM instance

This is a very basic interface that comes with the following limitations:

• The SPIM instances share the same address space with instances of SPIS, SPI, TWIM, TWIS, and TWI. You need to make sure that conflicting instances are disabled before using Spim. See product specification, section 15.2.
• The SPI mode is hardcoded to SPI mode 0.
• The frequency is hardcoded to 500 kHz.
• The over-read character is hardcoded to 0.

Methods

impl<T> Spim<T> where     T: SpimExt,

pub fn new(spim: T, pins: Pins) -> Spim<T>

pub fn read(     &mut self,     chip_select: &mut P0_Pin<Output<PushPull>>,     tx_buffer: &[u8],     rx_buffer: &mut [u8] ) -> Result<(), Error>

Read from an SPI slave

This method implements a complete read transaction, which consists of the master transmitting what it wishes to read, and the slave responding with the requested data.

Uses the provided chip select pin to initiate the transaction. Transmits all bytes in tx_buffer, then receives bytes until rx_buffer is full. Both buffer must have a length of at most 255 bytes.

pub fn write(     &mut self,     chip_select: &mut P0_Pin<Output<PushPull>>,     tx_buffer: &[u8] ) -> Result<(), Error>

Write to an SPI slave

This method uses the provided chip select pin to initiate the transaction, then transmits all bytes in tx_buffer.

The buffer must have a length of at most 255 bytes.

pub fn free(self) -> T

Return the raw interface to the underlying SPIM peripheral