Struct lpc845_pac::usart0::stat::W

pub struct W(_);

Register STAT writer

Implementations

impl W

pub fn deltacts(&mut self) -> DELTACTS_W<'_>

Bit 5 - This bit is set when a change in the state is detected for the CTS flag above. This bit is cleared by software.

pub fn overrunint(&mut self) -> OVERRUNINT_W<'_>

Bit 8 - Overrun Error interrupt flag. This flag is set when a new character is received while the receiver buffer is still in use. If this occurs, the newly received character in the shift register is lost.

pub fn deltarxbrk(&mut self) -> DELTARXBRK_W<'_>

Bit 11 - This bit is set when a change in the state of receiver break detection occurs.Cleared by software.

pub fn start(&mut self) -> START_W<'_>

Bit 12 - This bit is set when a start is detected on the receiver input. Its purpose is primarily to allow wake-up from Deep-sleep or Power-down mode immediately when a start is detected. Cleared by software.

pub fn framerrint(&mut self) -> FRAMERRINT_W<'_>

Bit 13 - Framing Error interrupt flag. This flag is set when a character is received with a missing stop bit at the expected location. This could be an indication of a baud rate or configuration mismatch with the transmitting source.

pub fn parityerrint(&mut self) -> PARITYERRINT_W<'_>

Bit 14 - Parity Error interrupt flag. This flag is set when a parity error is detected in a received character.

pub fn rxnoiseint(&mut self) -> RXNOISEINT_W<'_>

Bit 15 - Received Noise interrupt flag. Three samples of received data are taken in order to determine the value of each received data bit, except in synchronous mode. This acts as a noise filter if one sample disagrees. This flag is set when a received data bit contains one disagreeing sample. This could indicate line noise, a baud rate or character format mismatch, or loss of synchronization during data reception.

pub fn aberr(&mut self) -> ABERR_W<'_>

Bit 16 - Autobaud Error. An autobaud error can occur if the BRG counts to its limit before the end of the start bit that is being measured, essentially an autobaud time-out.

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<STAT_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Trait Implementations

impl Deref for W

type Target = W<STAT_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<STAT_SPEC>> for W

fn from(writer: W<STAT_SPEC>) -> Self

Performs the conversion.