Struct lpc845_pac::i2c0::mstctl::R

pub struct R(_);

Register MSTCTL reader

Implementations

impl R

pub fn mstcontinue(&self) -> MSTCONTINUE_R

Bit 0 - Master Continue.

pub fn mststart(&self) -> MSTSTART_R

Bit 1 - Master Start control.

pub fn mststop(&self) -> MSTSTOP_R

Bit 2 - Master Stop control.

pub fn mstdma(&self) -> MSTDMA_R

Bit 3 - Master DMA enable. Data operations of the I2C can be performed with DMA. Protocol type operations such as Start, address, Stop, and address match must always be done with software, typically via an interrupt. Address acknowledgement must also be done by software except when the I2C is configured to be HSCAPABLE (and address acknowledgement is handled entirely by hardware) or when Automatic Operation is enabled. When a DMA data transfer is complete, MSTDMA must be cleared prior to beginning the next operation, typically a Start or Stop.This bit is read/write.

Methods from Deref<Target = R<MSTCTL_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<MSTCTL_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<MSTCTL_SPEC>> for R

fn from(reader: R<MSTCTL_SPEC>) -> Self

Performs the conversion.