Struct lpc845_pac::capt::ctrl::POLLMODE_W

pub struct POLLMODE_W<'a> { /* fields omitted */ }

Field POLLMODE writer - Mode of operation. May only change from 0 to another value. So, if 2 or 3, must be changed to 0 1st. Any attempt to go from non-0 to non-0 will result in 0 anyway.

Implementations

impl<'a> POLLMODE_W<'a>

pub fn variant(self, variant: POLLMODE_A) -> &'a mut W

Writes variant to the field

pub fn none(self) -> &'a mut W

None, inactive. Poll and time counters are turned off. Writing this will reset state and stop any collection in progress. Note: this has no effect on STATUS - those must be cleared manually.

pub fn poll_now(self) -> &'a mut W

Poll now - forces a manual poll to be started immediately, using XPINSEL X pin(s) to activate in the integration loop (all pins set together). Self clears - clear is not indication it is done (see STATUS).

pub fn normal(self) -> &'a mut W

Normal polling using poll delay from POLL_TCNT register. This will start with the poll delay (which can be 0).

pub fn low_power_mode(self) -> &'a mut W

The CAPT block will operate in low-power mode. This means it will use GPIO as input, use combination touch measurements, and assume it is to wake the system. This will use the POLL_TCNT poll delay, and start with the delay.

pub fn bits(self, value: u8) -> &'a mut W

Writes raw bits to the field