Struct lpc845_pac::adc0::seq_ctrl::MODE_W

pub struct MODE_W<'a> { /* fields omitted */ }

Field MODE writer - Indicates whether the primary method for retrieving conversion results for this sequence will be accomplished via reading the global data register (SEQA_GDAT) at the end of each conversion, or the individual channel result registers at the end of the entire sequence. Impacts when conversion-complete interrupt/DMA trigger for sequence-A will be generated and which overrun conditions contribute to an overrun interrupt as described below.

Implementations

impl<'a> MODE_W<'a>

pub fn variant(self, variant: MODE_A) -> &'a mut W

Writes variant to the field

pub fn end_of_conversion(self) -> &'a mut W

End of conversion. The sequence A interrupt/DMA trigger will be set at the end of each individual ADC conversion performed under sequence A. This flag will mirror the DATAVALID bit in the SEQA_GDAT register. The OVERRUN bit in the SEQA_GDAT register will contribute to generation of an overrun interrupt/DMA trigger if enabled.

pub fn end_of_sequence(self) -> &'a mut W

End of sequence. The sequence A interrupt/DMA trigger will be set when the entire set of sequence-A conversions completes. This flag will need to be explicitly cleared by software or by the DMA-clear signal in this mode. The OVERRUN bit in the SEQA_GDAT register will NOT contribute to generation of an overrun interrupt/DMA trigger since it is assumed this register may not be utilized in this mode.

pub fn set_bit(self) -> &'a mut W

Sets the field bit

pub fn clear_bit(self) -> &'a mut W

Clears the field bit

pub fn bit(self, value: bool) -> &'a mut W

Writes raw bits to the field