Enum lpc82x_pac::adc0::seq_ctrl::MODE_A

pub enum MODE_A {
    END_OF_CONVERSION,
    END_OF_SEQUENCE,
}

Indicates whether the primary method for retrieving conversion results for this sequence will be accomplished via reading the global data register (SEQA_GDAT) at the end of each conversion, or the individual channel result registers at the end of the entire sequence. Impacts when conversion-complete interrupt/DMA trigger for sequence-A will be generated and which overrun conditions contribute to an overrun interrupt as described below.

Value on reset: 0

Variants

END_OF_CONVERSION

0: End of conversion. The sequence A interrupt/DMA trigger will be set at the end of each individual ADC conversion performed under sequence A. This flag will mirror the DATAVALID bit in the SEQA_GDAT register. The OVERRUN bit in the SEQA_GDAT register will contribute to generation of an overrun interrupt/DMA trigger if enabled.

END_OF_SEQUENCE

1: End of sequence. The sequence A interrupt/DMA trigger will be set when the entire set of sequence-A conversions completes. This flag will need to be explicitly cleared by software or by the DMA-clear signal in this mode. The OVERRUN bit in the SEQA_GDAT register will NOT contribute to generation of an overrun interrupt/DMA trigger since it is assumed this register may not be utilized in this mode.

Trait Implementations

impl From<MODE_A> for bool

fn from(variant: MODE_A) -> Self

Performs the conversion.

impl Debug for MODE_A

fn fmt(&self, f: &mut Formatter) -> Result

Formats the value using the given formatter.

impl PartialEq<MODE_A> for MODE_A

fn eq(&self, other: &MODE_A) -> bool

This method tests for self and other values to be equal, and is used by ==.

#[must_use] fn ne(&self, other: &Rhs) -> bool

This method tests for !=.

impl Copy for MODE_A

impl Clone for MODE_A

fn clone(&self) -> MODE_A

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.