[−][src]Type Definition lpc55s6x_pac::usbfsh::hcrhportstatus::W
type W = W<u32, HCRHPORTSTATUS>;
Writer for register HCRHPORTSTATUS
Methods
impl W
[src]
pub fn ccs(&mut self) -> CCS_W
[src]
Bit 0 - (read) CurrentConnectStatus This bit reflects the current state of the downstream port.
pub fn pes(&mut self) -> PES_W
[src]
Bit 1 - (read) PortEnableStatus This bit indicates whether the port is enabled or disabled.
pub fn pss(&mut self) -> PSS_W
[src]
Bit 2 - (read) PortSuspendStatus This bit indicates the port is suspended or in the resume sequence.
pub fn poci(&mut self) -> POCI_W
[src]
Bit 3 - (read) PortOverCurrentIndicator This bit is only valid when the Root Hub is configured in such a way that overcurrent conditions are reported on a per-port basis.
pub fn prs(&mut self) -> PRS_W
[src]
Bit 4 - (read) PortResetStatus When this bit is set by a write to SetPortReset, port reset signaling is asserted.
pub fn pps(&mut self) -> PPS_W
[src]
Bit 8 - (read) PortPowerStatus This bit reflects the porta's power status, regardless of the type of power switching implemented.
pub fn lsda(&mut self) -> LSDA_W
[src]
Bit 9 - (read) LowSpeedDeviceAttached This bit indicates the speed of the device attached to this port.
pub fn csc(&mut self) -> CSC_W
[src]
Bit 16 - ConnectStatusChange This bit is set whenever a connect or disconnect event occurs.
pub fn pesc(&mut self) -> PESC_W
[src]
Bit 17 - PortEnableStatusChange This bit is set when hardware events cause the PortEnableStatus bit to be cleared.
pub fn pssc(&mut self) -> PSSC_W
[src]
Bit 18 - PortSuspendStatusChange This bit is set when the full resume sequence is completed.
pub fn ocic(&mut self) -> OCIC_W
[src]
Bit 19 - PortOverCurrentIndicatorChange This bit is valid only if overcurrent conditions are reported on a per-port basis.
pub fn prsc(&mut self) -> PRSC_W
[src]
Bit 20 - PortResetStatusChange This bit is set at the end of the 10 ms port reset signal.