Type Definition lpc54606_pac::adc0::startup::W

type W = W<u32, STARTUP>;

Writer for register STARTUP

Methods

impl W

pub fn adc_ena(&mut self) -> ADC_ENA_W

Bit 0 - ADC Enable bit. This bit can only be set to a 1 by software. It is cleared automatically whenever the ADC is powered down. This bit must not be set until at least 10 microseconds after the ADC is powered up (typically by altering a system-level ADC power control bit).

pub fn adc_init(&mut self) -> ADC_INIT_W

Bit 1 - ADC Initialization. After enabling the ADC (setting the ADC_ENA bit), the API routine will EITHER set this bit or the CALIB bit in the CALIB register, depending on whether or not calibration is required. Setting this bit will launch the 'dummy' conversion cycle that is required if a calibration is not performed. It will also reload the stored calibration value from a previous calibration unless the BYPASSCAL bit is set. This bit should only be set AFTER the ADC_ENA bit is set and after the CALIREQD bit is tested to determine whether a calibration or an ADC dummy conversion cycle is required. It should not be set during the same write that sets the ADC_ENA bit. This bit can only be set to a '1' by software. It is cleared automatically when the 'dummy' conversion cycle completes.