Rust LM75 Temperature Sensor and Thermal Watchdog Driver

This is a platform agnostic Rust driver for the LM75 temperature sensor and thermal watchdog, based on the embedded-hal traits.

This driver allows you to:

• Enable/disable the device.
• Read the temperature.
• Set the fault queue.
• Set the OS temperature.
• Set the hysteresis temperature.
• Set the OS operation mode.
• Set the OS polarity.

The device

The LM75 temperature sensor includes a delta-sigma analog-to-digital converter, and a digital overtemperature detector. The host can query the LM75 through its I2C interface to read temperature at any time. The open-drain overtemperature output (OS) sinks current when the programmable temperature limit is exceeded. The OS output operates in either of two modes, comparator or interrupt. The host controls the temperature at which the alarm is asserted (TOS) and the hysteresis temperature below which the alarm condition is not valid (THYST). Also, the LM75's TOS and THYST registers can be read by the host. The address of the LM75 is set with three pins to allow multiple devices to work on the same bus. Power-up is in comparator mode, with defaults of TOS= +80ºC and THYST= +75ºC. The 3.0V to 5.5V supply voltage range, low supply current, and I2C interface make the LM75 ideal for many applications in thermal management and protection.

Datasheet:

• LM75

This driver is also compatible with LM75A, LM75B and LM75C: LM75B/C Datasheet

And also at least with the devices MAX7500, MAX6625, MAX6626, DS75LV, and DS7505.

License

Licensed under either of

• Apache License, Version 2.0 (LICENSE-APACHE or http://www.apache.org/licenses/LICENSE-2.0)
• MIT license (LICENSE-MIT or http://opensource.org/licenses/MIT) at your option.

Contributing

Unless you explicitly state otherwise, any contribution intentionally submitted for inclusion in the work by you, as defined in the Apache-2.0 license, shall be dual licensed as above, without any additional terms or conditions.