[−][src]Struct k22f::i2c0::c1::DMAEN_W
Write proxy for field DMAEN
Methods
impl<'a> DMAEN_W<'a>
[src]
pub fn variant(self, variant: DMAEN_A) -> &'a mut W
[src]
Writes variant
to the field
pub fn _0(self) -> &'a mut W
[src]
All DMA signalling disabled.
pub fn _1(self) -> &'a mut W
[src]
DMA transfer is enabled and the following conditions trigger the DMA request: While FACK = 0, a data byte is received, either address or data is transmitted. (ACK/NACK automatic) While FACK = 0, the first byte received matches the A1 register or is general call address. If any address matching occurs, IAAS and TCF are set. If the direction of transfer is known from master to slave, then it is not required to check the SRW. With this assumption, DMA can also be used in this case. In other cases, if the master reads data from the slave, then it is required to rewrite the C1 register operation. With this assumption, DMA cannot be used. When FACK = 1, an address or a data byte is transmitted.
pub fn set_bit(self) -> &'a mut W
[src]
Sets the field bit
pub fn clear_bit(self) -> &'a mut W
[src]
Clears the field bit
pub fn bit(self, value: bool) -> &'a mut W
[src]
Writes raw bits to the field
Auto Trait Implementations
Blanket Implementations
impl<T> Any for T where
T: 'static + ?Sized,
[src]
T: 'static + ?Sized,
impl<T> Borrow<T> for T where
T: ?Sized,
[src]
T: ?Sized,
impl<T> BorrowMut<T> for T where
T: ?Sized,
[src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T
[src]
impl<T> From<T> for T
[src]
impl<T, U> Into<U> for T where
U: From<T>,
[src]
U: From<T>,
impl<T> Same<T> for T
type Output = T
Should always be Self
impl<T, U> TryFrom<U> for T where
U: Into<T>,
[src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>
[src]
impl<T, U> TryInto<U> for T where
U: TryFrom<T>,
[src]
U: TryFrom<T>,