Type Definition imxrt1062_dcdc::reg1::R

type R = R<u32, REG1>;

Reader of register REG1

Methods

impl R

pub fn reg_fbk_sel(&self) -> REG_FBK_SEL_R

Bits 7:8 - select the feedback point of the internal regulator

pub fn reg_rload_sw(&self) -> REG_RLOAD_SW_R

Bit 9 - control the load resistor of the internal regulator of DCDC, the load resistor is connected as default "1", and need set to "0" to disconnect the load resistor

pub fn lp_cmp_isrc_sel(&self) -> LP_CMP_ISRC_SEL_R

Bits 12:13 - set the current bias of low power comparator 0x0: 50 nA 0x1: 100 nA 0x2: 200 nA 0x3: 400 nA

pub fn loopctrl_hst_thresh(&self) -> LOOPCTRL_HST_THRESH_R

Bit 21 - increase the threshold detection for common mode analog comparator

pub fn loopctrl_en_hyst(&self) -> LOOPCTRL_EN_HYST_R

Bit 23 - Enable hysteresis in switching converter common mode analog comparators

pub fn vbg_trim(&self) -> VBG_TRIM_R

Bits 24:28 - trim bandgap voltage