esp32c3-hal 0.7.0

//! Connect a potentiometer to PIN2 and see the read values change when
//! rotating the shaft. Alternatively you could also connect the PIN to GND or
//! 3V3 to see the maximum and minimum raw values read.

#![no_std]
#![no_main]

use esp32c3_hal::{
    adc::{AdcConfig, Attenuation, ADC, ADC1},
    clock::ClockControl,
    gpio::IO,
    peripherals::Peripherals,
    prelude::*,
    timer::TimerGroup,
    Delay,
    Rtc,
};
use esp_backtrace as _;
use esp_println::println;

#[entry]
fn main() -> ! {
    let peripherals = Peripherals::take();
    let mut system = peripherals.SYSTEM.split();
    let clocks = ClockControl::boot_defaults(system.clock_control).freeze();

    // Disable the watchdog timers. For the ESP32-C3, this includes the Super WDT,
    // the RTC WDT, and the TIMG WDTs.
    let mut rtc = Rtc::new(peripherals.RTC_CNTL);
    let timer_group0 = TimerGroup::new(peripherals.TIMG0, &clocks);
    let mut wdt0 = timer_group0.wdt;
    let timer_group1 = TimerGroup::new(peripherals.TIMG1, &clocks);
    let mut wdt1 = timer_group1.wdt;

    rtc.swd.disable();
    rtc.rwdt.disable();
    wdt0.disable();
    wdt1.disable();

    let io = IO::new(peripherals.GPIO, peripherals.IO_MUX);

    // Create ADC instances
    let analog = peripherals.APB_SARADC.split();

    let mut adc1_config = AdcConfig::new();

    let mut pin = adc1_config.enable_pin(io.pins.gpio2.into_analog(), Attenuation::Attenuation11dB);

    let mut adc1 = ADC::<ADC1>::adc(
        &mut system.peripheral_clock_control,
        analog.adc1,
        adc1_config,
    )
    .unwrap();

    let mut delay = Delay::new(&clocks);

    loop {
        let pin_value: u16 = nb::block!(adc1.read(&mut pin)).unwrap();
        println!("PIN2 ADC reading = {}", pin_value);
        delay.delay_ms(1500u32);
    }
}