Struct cc2650::crypto::keywritearea::R

pub struct R { /* fields omitted */ }

Value read from the register

Methods

impl R

pub fn bits(&self) -> u32

Value of the register as raw bits

pub fn reserved8(&self) -> RESERVED8R

Bits 8:31 - Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.

pub fn ram_area7(&self) -> RAM_AREA7R

Bit 7 - Represents an area of 128 bits. Select the key store RAM area(s) where the key(s) needs to be written. Writing to multiple RAM locations is only possible when the selected RAM areas are sequential.

pub fn ram_area6(&self) -> RAM_AREA6R

Bit 6 - Represents an area of 128 bits. Select the key store RAM area(s) where the key(s) needs to be written. Writing to multiple RAM locations is only possible when the selected RAM areas are sequential.

pub fn ram_area5(&self) -> RAM_AREA5R

Bit 5 - Represents an area of 128 bits. Select the key store RAM area(s) where the key(s) needs to be written. Writing to multiple RAM locations is only possible when the selected RAM areas are sequential.

pub fn ram_area4(&self) -> RAM_AREA4R

Bit 4 - Represents an area of 128 bits. Select the key store RAM area(s) where the key(s) needs to be written. Writing to multiple RAM locations is only possible when the selected RAM areas are sequential.

pub fn ram_area3(&self) -> RAM_AREA3R

Bit 3 - Represents an area of 128 bits. Select the key store RAM area(s) where the key(s) needs to be written. Writing to multiple RAM locations is only possible when the selected RAM areas are sequential.

pub fn ram_area2(&self) -> RAM_AREA2R

Bit 2 - Represents an area of 128 bits. Select the key store RAM area(s) where the key(s) needs to be written. Writing to multiple RAM locations is only possible when the selected RAM areas are sequential.

pub fn ram_area1(&self) -> RAM_AREA1R

Bit 1 - Represents an area of 128 bits. Select the key store RAM area(s) where the key(s) needs to be written. Writing to multiple RAM locations is only possible when the selected RAM areas are sequential.

pub fn ram_area0(&self) -> RAM_AREA0R

Bit 0 - Represents an area of 128 bits. Select the key store RAM area(s) where the key(s) needs to be written. Writing to multiple RAM locations is only possible when the selected RAM areas are sequential.