[−][src]Struct cc2650::aon_wuc::mcuclk::R
Value read from the register
Methods
impl R[src]
pub fn bits(&self) -> u32[src]
Value of the register as raw bits
pub fn reserved3(&self) -> RESERVED3R[src]
Bits 3:31 - Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.
pub fn rcosc_hf_cal_done(&self) -> RCOSC_HF_CAL_DONER[src]
Bit 2 - MCU bootcode will set this bit when RCOSC_HF is calibrated. The FLASH can not be used until this bit is set. 1: RCOSC_HF is calibrated to 48 MHz, allowing FLASH to power up. 0: RCOSC_HF is not yet calibrated, ie FLASH must not assume that the SCLK_HF is safe
pub fn pwr_dwn_src(&self) -> PWR_DWN_SRCR[src]
Bits 0:1 - Controls the clock source for the entire MCU domain while MCU is requesting powerdown. When MCU requests powerdown with SCLK_HF as source, then WUC will switch over to this clock source during powerdown, and automatically switch back to SCLK_HF when MCU is no longer requesting powerdown and system is back in active mode.
Auto Trait Implementations
Blanket Implementations
impl<T> From for T[src]
impl<T, U> TryFrom for T where
U: Into<T>, [src]
U: Into<T>,
type Error = Infallible
The type returned in the event of a conversion error.
fn try_from(value: U) -> Result<T, <T as TryFrom<U>>::Error>[src]
impl<T, U> TryInto for T where
U: TryFrom<T>, [src]
U: TryFrom<T>,
type Error = <U as TryFrom<T>>::Error
The type returned in the event of a conversion error.
fn try_into(self) -> Result<U, <U as TryFrom<T>>::Error>[src]
impl<T, U> Into for T where
U: From<T>, [src]
U: From<T>,
impl<T> Borrow for T where
T: ?Sized, [src]
T: ?Sized,
impl<T> BorrowMut for T where
T: ?Sized, [src]
T: ?Sized,
fn borrow_mut(&mut self) -> &mut T[src]
impl<T> Any for T where
T: 'static + ?Sized, [src]
T: 'static + ?Sized,