1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64
#[doc = "Reader of register FREQEST"] pub type R = crate::R<u32, super::FREQEST>; #[doc = "Writer for register FREQEST"] pub type W = crate::W<u32, super::FREQEST>; #[doc = "Register FREQEST `reset()`'s with value 0"] impl crate::ResetValue for super::FREQEST { type Type = u32; #[inline(always)] fn reset_value() -> Self::Type { 0 } } #[doc = "Reader of field `Reserved32`"] pub type RESERVED32_R = crate::R<u32, u32>; #[doc = "Write proxy for field `Reserved32`"] pub struct RESERVED32_W<'a> { w: &'a mut W, } impl<'a> RESERVED32_W<'a> { #[doc = r"Writes raw bits to the field"] #[inline(always)] pub unsafe fn bits(self, value: u32) -> &'a mut W { self.w.bits = (self.w.bits & !(0x00ff_ffff << 8)) | (((value as u32) & 0x00ff_ffff) << 8); self.w } } #[doc = "Reader of field `FREQEST`"] pub type FREQEST_R = crate::R<u8, u8>; #[doc = "Write proxy for field `FREQEST`"] pub struct FREQEST_W<'a> { w: &'a mut W, } impl<'a> FREQEST_W<'a> { #[doc = r"Writes raw bits to the field"] #[inline(always)] pub unsafe fn bits(self, value: u8) -> &'a mut W { self.w.bits = (self.w.bits & !0xff) | ((value as u32) & 0xff); self.w } } impl R { #[doc = "Bits 8:31 - 31:8\\] This register is 8 bits in a 32-bit address space."] #[inline(always)] pub fn reserved32(&self) -> RESERVED32_R { RESERVED32_R::new(((self.bits >> 8) & 0x00ff_ffff) as u32) } #[doc = "Bits 0:7 - 7:0\\] Signed 2's-complement value. Contains an estimate of the frequency offset between carrier and the receiver LO. The offset frequency is FREQEST x 7800 Hz. DEM_AVG_MODE controls when this estimate is updated. If DEM_AVG_MODE = 0, it is updated until sync is found. Then the frequency offset estimate is frozen until the end of the received frame. If DEM_AVG_MODE = 1, it is updated as long as the demodulator is enabled. To calculate the correct value, one must use an offset (FREQEST_offset), which can be found in the device data sheet. Real FREQEST value = FREQEST - FREQEST_offset."] #[inline(always)] pub fn freqest(&self) -> FREQEST_R { FREQEST_R::new((self.bits & 0xff) as u8) } } impl W { #[doc = "Bits 8:31 - 31:8\\] This register is 8 bits in a 32-bit address space."] #[inline(always)] pub fn reserved32(&mut self) -> RESERVED32_W { RESERVED32_W { w: self } } #[doc = "Bits 0:7 - 7:0\\] Signed 2's-complement value. Contains an estimate of the frequency offset between carrier and the receiver LO. The offset frequency is FREQEST x 7800 Hz. DEM_AVG_MODE controls when this estimate is updated. If DEM_AVG_MODE = 0, it is updated until sync is found. Then the frequency offset estimate is frozen until the end of the received frame. If DEM_AVG_MODE = 1, it is updated as long as the demodulator is enabled. To calculate the correct value, one must use an offset (FREQEST_offset), which can be found in the device data sheet. Real FREQEST value = FREQEST - FREQEST_offset."] #[inline(always)] pub fn freqest(&mut self) -> FREQEST_W { FREQEST_W { w: self } } }