[−][src]Module cc13x2_cc26x2_hal::aux_tdc::prectl
Prescaler Control The prescaler can be used to count events that are faster than the AUX bus rate. It can be used to: - count pulses on a specified event from the asynchronous event bus. - prescale a specified event from the asynchronous event bus. To use the prescaler output as an event source in TDC measurements you must set both TRIGSRC.START_SRC and TRIGSRC.STOP_SRC to AUX_TDC_PRE. It is recommended to use the prescaler when the signal frequency to measure exceeds 1/10th of the AUX bus rate.
Structs
| R | Value read from the register |
| RESERVED8R | Value of the field |
| RESET_NR | Value of the field |
| W | Value to write to the register |
| _RATIOW | Proxy |
| _RESERVED8W | Proxy |
| _RESET_NW | Proxy |
| _SRCW | Proxy |
Enums
| RATIOR | Possible values of the field |
| RATIOW | Values that can be written to the field |
| SRCR | Possible values of the field |
| SRCW | Values that can be written to the field |