Struct cc13x2_cc26x2_hal::crypto::KEYWRITEAREA

pub struct KEYWRITEAREA { /* fields omitted */ }

Key Store Write Area This register defines where the keys should be written in the key store RAM. After writing this register, the key store module is ready to receive the keys through a DMA operation. In case the key data transfer triggered an error in the key store, the error will be available in the interrupt status register after the DMA is finished. The key store write-error is asserted when the programmed/selected area is not completely written. This error is also asserted when the DMA operation writes to ram areas that are not selected. The key store RAM is divided into 8 areas of 128 bits. 192-bit keys written in the key store RAM should start on boundaries of 256 bits. This means that writing a 192-bit key to the key store RAM must be done by writing 256 bits of data with the 64 most-significant bits set to 0. These bits are ignored by the AES engine.

Methods

impl KEYWRITEAREA

pub fn modify<F>(&self, f: F) where
    F: FnOnce(&R, &'w mut W) -> &'w mut W, 

Modifies the contents of the register

pub fn read(&self) -> R

Reads the contents of the register

pub fn write<F>(&self, f: F) where
    F: FnOnce(&mut W) -> &mut W, 

Writes to the register

pub fn reset(&self)

Writes the reset value to the register