Struct atsam4lc8b_pac::bpm::bpr::R

pub struct R(_);

Register BPR reader

Implementations

impl R

pub fn runpspb(&self) -> RUNPSPB_R

Bit 0 - Run Mode Power Scaling Preset Bypass

pub fn psmpspb(&self) -> PSMPSPB_R

Bit 1 - Power Save Mode Power Scaling Preset Bypass

pub fn seqstn(&self) -> SEQSTN_R

Bit 2 - Sequencial Startup from ULP (Active Low)

pub fn psbtd(&self) -> PSBTD_R

Bit 3 - Power Scaling Bias Timing Disable

pub fn pshfd(&self) -> PSHFD_R

Bit 4 - Power Scaling Halt Flash Until VREGOK Disable

pub fn dlyrstd(&self) -> DLYRSTD_R

Bit 5 - Delaying Reset Disable

pub fn biassen(&self) -> BIASSEN_R

Bit 6 - Bias Switch Enable

pub fn latsen(&self) -> LATSEN_R

Bit 7 - Latdel Switch Enable

pub fn bod18cont(&self) -> BOD18CONT_R

Bit 8 - BOD18 in continuous mode not disabled in WAIT/RET/BACKUP modes

pub fn pobs(&self) -> POBS_R

Bit 9 - Pico Uart Observability

pub fn fffw(&self) -> FFFW_R

Bit 10 - Force Flash Fast Wakeup

pub fn fbrdyen(&self) -> FBRDYEN_R

Bit 11 - Flash Bias Ready Enable

pub fn fvrefsen(&self) -> FVREFSEN_R

Bit 12 - Flash Vref Switch Enable

Methods from Deref<Target = R<BPR_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<BPR_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<BPR_SPEC>> for R

fn from(reader: R<BPR_SPEC>) -> Self

Performs the conversion.