[−][src]Enum cntrlr::hw::board::red_v::io::SerialError

#[non_exhaustive]pub enum SerialError {
    NotEnabled,
    PinInUse,
    UartInUse,
    GpioInUse,
    InvalidBaud,
}
This is supported on board="red_v" only.

An error from a serial interface

Variants (Non-exhaustive)

Non-exhaustive enums could have additional variants added in future. Therefore, when matching against variants of non-exhaustive enums, an extra wildcard arm must be added to account for any future variants.
NotEnabled

The serial port cannot be read or written because it is disabled

PinInUse

The serial port cannot be enabled because its TX or RX pin is in use

UartInUse

The serial port cannot be enabled because its UART is in use

GpioInUse

The serial port cannot be enabled because the GPIO is in use

InvalidBaud

The serial port cannot be enabled because the selected baud rate is invalid

Trait Implementations

impl Debug for SerialError[src]

Auto Trait Implementations

Blanket Implementations

impl<T> Any for T where
    T: 'static + ?Sized, [src]

impl<T> Borrow<T> for T where
    T: ?Sized, [src]

impl<T> BorrowMut<T> for T where
    T: ?Sized, [src]

impl<T> From<T> for T[src]

impl<T, U> Into<U> for T where
    U: From<T>, [src]

impl<T, U> TryFrom<U> for T where
    U: Into<T>, [src]

type Error = Infallible

The type returned in the event of a conversion error.

impl<T, U> TryInto<U> for T where
    U: TryFrom<T>, [src]

type Error = <U as TryFrom<T>>::Error

The type returned in the event of a conversion error.