Struct cc2650::cpu_tpiu::FFCR

pub struct FFCR { /* fields omitted */ }

Formatter and Flush Control When one of the two single wire output (SWO) modes is selected, ENFCONT enables the formatter to be bypassed. If the formatter is bypassed, only the ITM/DWT trace source (ATDATA2) passes through. The TPIU accepts and discards data that is presented on the ETM port (ATDATA1). This function is intended to be used when it is necessary to connect a device containing an ETM to a trace capture device that is only able to capture Serial Wire Output (SWO) data. Enabling or disabling the formatter causes momentary data corruption. Note: If the selected pin protocol register (SPPR.PROTOCOL) is set to 0x00 (TracePort mode), this register always reads 0x102, because the formatter is automatically enabled. If one of the serial wire modes is then selected, the register reverts to its previously programmed value.

Methods

impl FFCR

pub fn modify<F>(&self, f: F) where
    F: FnOnce(&R, &'w mut W) -> &'w mut W, 

Modifies the contents of the register

pub fn read(&self) -> R

Reads the contents of the register

pub fn write<F>(&self, f: F) where
    F: FnOnce(&mut W) -> &mut W, 

Writes to the register

pub fn reset(&self)

Writes the reset value to the register