[−][src]Module cc13x2_cc26x2_pac::aux_tdc::prectl
Prescaler Control The prescaler can be used to count events that are faster than the AUX bus rate. It can be used to: - count pulses on a specified event from the asynchronous event bus. - prescale a specified event from the asynchronous event bus. To use the prescaler output as an event source in TDC measurements you must set both TRIGSRC.START_SRC and TRIGSRC.STOP_SRC to AUX_TDC_PRE. It is recommended to use the prescaler when the signal frequency to measure exceeds 1/10th of the AUX bus rate.
Structs
R | Value read from the register |
RESERVED8R | Value of the field |
RESET_NR | Value of the field |
W | Value to write to the register |
_RATIOW | Proxy |
_RESERVED8W | Proxy |
_RESET_NW | Proxy |
_SRCW | Proxy |
Enums
RATIOR | Possible values of the field |
RATIOW | Values that can be written to the field |
SRCR | Possible values of the field |
SRCW | Values that can be written to the field |