Struct cc13x2_cc26x2_hal::udma0::cfg::R

pub struct R { /* fields omitted */ }

Value read from the register

Methods

impl R

pub fn bits(&self) -> u32

Value of the register as raw bits

pub fn reserved8(&self) -> RESERVED8R

Bits 8:31 - 31:8] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.

pub fn prtoctrl(&self) -> PRTOCTRLR

Bits 5:7 - 7:5] Sets the AHB-Lite bus protocol protection state by controlling the AHB signal HProt[3:1] as follows: Bit [7] Controls HProt[3] to indicate if a cacheable access is occurring. Bit [6] Controls HProt[2] to indicate if a bufferable access is occurring. Bit [5] Controls HProt[1] to indicate if a privileged access is occurring. When bit [n] = 1 then the corresponding HProt bit is high. When bit [n] = 0 then the corresponding HProt bit is low. This field controls HProt[3:1] signal for all transactions initiated by uDMA except two transactions below: - the read from the address indicated by source address pointer - the write to the address indicated by destination address pointer HProt[3:1] for these two exceptions can be controlled by dedicated fields in the channel configutation descriptor.

pub fn reserved1(&self) -> RESERVED1R

Bits 1:4 - 4:1] Software should not rely on the value of a reserved. Writing any other value than the reset value may result in undefined behavior.

pub fn masterenable(&self) -> MASTERENABLER

Bit 0 - 0:0] Enables the controller: 0: Disables the controller 1: Enables the controller